![]() The water cannot be allowed to boil in the heat exchanger. That’s well below atmospheric pressure, but it would only take about 33 feet 10 inches of water column in the discharge pipe to achieve that. At 53 F, water will boil if the pressure drops to. It’s because of the boiling point of water. The lower the water level in the well, the deeper the vacuum will be. ![]() The weight of the water in the discharge pipe will cause the water pressure at the top of the pipe to drop into a vacuum (below atmospheric pressure). You must maintain positive water pressure inside the heat exchanger of the geothermal unit. This setup has to be configured properly to work though. That’s good for everyone! See, the weight of the water in the discharge pipe is pulling the water from the one side, while the pump is pushing water from the other side. This way the pump does not have to work as hard and uses less electricity. ![]() ![]() Typically, the discharge pipe will be lowered into the well so that the end of the pipe is below the water level in the well. It will have the discharge pipe from the geo unit, and this is where all the water goes after the geo unit has extracted or added the BTUs it needs for heating or cooling. The other well is the “dump well” for the geothermal unit. One well will have a constant pressure pump installed and supply water for the residence as well as the geothermal unit. Usually people who have this type of setup have two wells. This is an application where ground water is pumped through the unit and then dumped back into the ground. Now we are talking about a fresh water, “pump and dump” system. The question comes up again and again: what type of valve should I use for my geothermal unit? ![]()
0 Comments
![]() ![]() However, it’s good to keep this in mind, especially if you’re using the ad supported service and want to maintain your privacy. The Premium version of Hotspot Shield does not run this risk. Individuals who use the free version run the risk of their personal information being leaked to advertisers. Hotspot Shield says that this information is never associated with you and is only used for analytic purposes. Hotspot Shield will gather information such as the OS version you are using, the browser you are using, information on your mobile network, as well as the hardware that you are using. However, if you are privacy-conscious, Hotspot Shield may not be the right option for you. They state that the information they collect is not used to identify you. AnchorFree, the parent company behind Hotspot Shield, says that this information is collected only for analytic and troubleshooting purposes. ![]() However, they do collect data about the websites you visit and the apps you use. Hotspot Shield’s privacy policy says that they will not store your IP address long-term. ![]() ![]() ![]() Version 5 has 40% faster installation and setup and 40% less RAM consumption. Also, some functions necessary during long gaming sessions were added. The advantages of the updated emulator are fast startup, simple interface, high frame rate (FPS), reduced memory consumption. ![]() The latest version of BlueStacks 5 was released on February 15, 2021. The creators of the emulator are official partners of most phone software developers, so when opening a mobile application on your computer, users can not be afraid of having their account blocked due to unauthorized interference with the program. Bluestacks App Player program is compatible with all applications from the online store Google Play. ![]() The emulator is used to run Android apps on Windows PC and Mac. The development is managed by Rosen Sharma, formerly the CTO of McAfee Corp. The first version of the program appeared in October 2011, and later the application was updated several times. BlueStacks App Player is the brainchild of the company with the same name from the United States. ![]() |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |